# Configuration for lutron-dmx-control.
#
# Copy this file to config.yaml (kept out of git) and edit it:
#   sudo install -d /etc/lutron-dmx-control
#   sudo cp config.example.yaml /etc/lutron-dmx-control/config.yaml
#   sudo chmod 600 /etc/lutron-dmx-control/config.yaml   # contains the MQTT password
#
# The program searches for the config in this order:
#   1. --config PATH on the command line
#   2. $LUTRON_CONFIG
#   3. config.yaml next to the script
#   4. ~/.config/lutron-dmx-control/config.yaml
#   5. /etc/lutron-dmx-control/config.yaml

# --- QSE NWK serial link ---
serial:
  # Find yours with: ls -lah /dev/serial/by-id/
  device: /dev/serial/by-id/usb-Prolific_Technology_Inc._USB-Serial_Controller-if00-port0
  # Must match the dipswitch on the QSE-CI-NWK-E (9600/19200/38400/115200).
  baud: 115200

# --- GRAFIK Eye QS ---
qse:
  integration_id: 1   # Integration ID bound to the GRAFIK Eye main unit
  zones: 6            # Controllable zones on your model (max 24)
  fade: "00:00"      # Fade sent with each level command; "00:00" = instant (OLA fades)

# --- DMX (OLA) ---
# Optional. Set enabled: false to run without DMX (e.g. MQTT-only control); when
#  disabled, OLA does not need to be installed.
dmx:
  enabled: true
  universe: 3
  start_address: 0    # 0-indexed offset of zone 1 within the universe
  # While a DMX signal is active, MQTT commands are locked out so DMX stays in
  #  control. This is how long (seconds) after the last DMX universe update the
  #  lockout persists; once it elapses MQTT can drive the lights again.
  lockout_sec: 5

# --- Reliability tuning (optional; defaults shown) ---
reliability:
  rx_timeout_sec: 60
  watchdog_interval_sec: 15
  reconnect_backoff_min_sec: 1
  reconnect_backoff_max_sec: 30
  send_all_interval_sec: 10

# --- Logging ---
logging:
  level: INFO          # DEBUG for verbose TX/RX tracing

# --- MQTT / Home Assistant ---
# Optional. Set enabled: false to disable; when disabled, paho-mqtt does not
#  need to be installed.
mqtt:
  enabled: true
  broker: 127.0.0.1
  port: 1883
  topic: lutron/qse-nwk
  username: mqtt
  password: change-me
  client_id: null      # null -> auto-generated
  # Publish a Home Assistant MQTT discovery config so the light appears
  #  automatically (no manual configuration.yaml entry needed).
  discovery: true
  discovery_prefix: homeassistant
  device_name: Lutron QSE NWK